Avision av3750 Manuale Utente

 

 

 

 

 

When you have several devices on a SCSI chain, you may 

need to adjust the SCSI ID selector setting located on the 

back of the scanner. This setting assigns a specific "device 

ID" to the scanner.    If the assignment conflicts with an 

existing SCSI device, please select a new ID. (See Figure 2-

2) 

Note: The factory setting for scanner is ID 6.    Usually, ID 0 

is assigned to an internal hard disk drive, and ID 7, ID 8 ,and 

ID 9 are not in actual use. 

Using a suitable tool, turn the selector switch until the arrow 

points to the desired ID number. 

Setting SCSI Terminator   

The scanner is equipped with a built-in terminator switch on 

the rear of the scanner. (See Figure 2-2). The scanner is 

equipped with a built-in terminator switch on the rear of the 

scanner. Turn the terminator switch on if the scanner is to be 

connected to the computer as the only or the last SCSI 

device. Turn the terminator switch off if the scanner is to be 

located between the computer and the other SCSI device.