HP 20-700 Manuale Utente

116 Operating in Automated Mode

Chapter 4

Running Drive Diagnostic Tests

To run a diagnostic test on a drive:
1.  Ensure the library is not in use.
2. Press 

the 

[MENU] button until the Main Menu displays.

3.  Press the arrow buttons until the cursor underscores DIAGNOSTICS.
4. Press the [SELECT] button.

The panel displays the Main Diagnostics Menu. 

5.  Press the arrow buttons until the cursor underscores DRIVE DIAGNOSTICS.
6. Press 

the [SELECT] button.

The screen will display a list of installed drives.

7.  Use the arrow buttons to highlight the desired drive.
8. Press the [SELECT] button.

The Diagnostics Drive Menu appears.

9.  Press the arrow buttons until the cursor underscores the desired test. For a 

description of the available tests, see 

10. Press the [SELECT] button.

If you selected MOUNT/DISMOUNT LOOP, an editing screen will appear:
a.  Use the arrow buttons to enter the desired value. (The up arrow button 

increases the value; the down arrow button decreases the value.)

b. Press 

the 

[SELECT] button.

11. You will be prompted to confirm that you want the library in Maintenance 

Mode (offline) before beginning the test (ARE YOU SURE?). Confirm this 

by pressing the [SELECT] button. (You may press the [MENU] button to 

abort.)

12. Wait until the test is completed; the screen will display a message that 

either the test completed successfully or, if a problem occurred, the screen 

will display an error message and, in some cases, an FSC code.