HP 20-700 Manuale Utente
138 Manual Operation
Chapter 4
Unloading a Cartridge from an Ultrium Drive
To unload a cartridge from an Ultrium drive:
1. Ensure that the drive is not in use.
2. Open the tape library right front door by pulling on the left side of the
1. Ensure that the drive is not in use.
2. Open the tape library right front door by pulling on the left side of the
door.
3. Open the tape library left front door by using a latch key to unlock both
locks. See
on page 123. (Turn the key counter clockwise to
unlock them, then pull open the door.)
4.
Press the
[Unload] button on the front panel of the drive
.
One of the following conditions can occur:
— After the tape rewinds, the cartridge ejects from the drive. Remove the
— After the tape rewinds, the cartridge ejects from the drive. Remove the
cartridge from the drive.
— The cartridge fails to eject after the tape rewinds. Hold the [Unload]
button for 10 to 15 seconds to try to force an eject from the drive. If
not successful, contact your service representative.