HP color laserjet 3000n Manuale Utente
ENWW
3-9
To install memory and font DIMMs
CAUTION
DIMMs contain electronic components that can be damaged by
static electricity. To prevent buildup of static electricity, maintain
frequent contact with any bare sheet metal surface on the printer.
If possible, wear a grounding wrist strap (or similar device).
Handle DIMMs carefully at all times. Avoid touching electronic
components or circuit paths.
static electricity. To prevent buildup of static electricity, maintain
frequent contact with any bare sheet metal surface on the printer.
If possible, wear a grounding wrist strap (or similar device).
Handle DIMMs carefully at all times. Avoid touching electronic
components or circuit paths.
1
If you have not already done so, print a Configuration page to find
out how much memory is installed in the printer before adding more
memory. See “
out how much memory is installed in the printer before adding more
memory. See “
.”
2
Press and hold
(power button) to turn off the printer.
3
Unplug the power cord and disconnect any cables.
4
To remove the DIMM cover from the back of the printer, insert a
flathead screwdriver into the top slot. Gently push down on the
screwdriver's handle with one hand, grasp the cover with the other
hand, and remove the cover.
flathead screwdriver into the top slot. Gently push down on the
screwdriver's handle with one hand, grasp the cover with the other
hand, and remove the cover.
5
Remove the DIMM from the antistatic package, and then align the
DIMM with an empty DIMM slot.
DIMM with an empty DIMM slot.
6
On the DIMM slot, push the DIMM locks outward to release
the locks.
the locks.
7
Insert the DIMM into the slot (item 1 in the graphic) and press it into
the printer until it snaps into the slot (item 2 in the graphic).
the printer until it snaps into the slot (item 2 in the graphic).