HP color laserjet 9500mfp Manuale Utente
setting. For example, for the HP color LaserJet 9500mfp, trays 1 and 4 are listed in both the Form to
Tray Assignment setting and the Installable Options setting.
Tray Assignment setting and the Installable Options setting.
The input trays listed here are also listed as media sources on the Page Setup tab.
Font Substitution Table
Clicking this option opens the font substitution table and makes available the options for changing
the TrueType-to-PostScript font mapping.
the TrueType-to-PostScript font mapping.
PostScript Configurations
The following controls are available and appear in the PS Emulation Driver.
Available PostScript Memory
This control specifies the amount of available postscript memory and provides a spin box for
changing this value. The available postscript memory is a subset of the product total physical
memory. It is usually best to set the postscript memory to match what is shown on the configuration
page. To print a configuration page from the control panel, press the Select button (the one with the
check mark) to open the menus. Next, press the up and down buttons to scroll to INFORMATION,
and then press the
changing this value. The available postscript memory is a subset of the product total physical
memory. It is usually best to set the postscript memory to match what is shown on the configuration
page. To print a configuration page from the control panel, press the Select button (the one with the
check mark) to open the menus. Next, press the up and down buttons to scroll to INFORMATION,
and then press the
SELECT
button. Next, press the up and down buttons to scroll to PRINT
CONFIGURATION, and then press the
SELECT
button.
Output Protocol
This control specifies the protocol that the product uses for print jobs. The following options are
available:
available:
■
ASCII (default)
■
TBCP
■
Binary
When you click ASCII, data is sent in ASCII format (7-bit), which might take longer to print but can be
sent through any I/O channel, such as a serial, parallel, or network port.
sent through any I/O channel, such as a serial, parallel, or network port.
When you click TBCP (Tagged Binary Communications Protocol), all data except special control
characters is sent in binary (8-bit) format. The binary formats can be sent over parallel or serial
communications ports and are faster than sending data in ASCII format.
characters is sent in binary (8-bit) format. The binary formats can be sent over parallel or serial
communications ports and are faster than sending data in ASCII format.
When you click Binary, all data except special control characters is sent in binary (8-bit) format. The
binary formats can be sent over parallel or serial communications ports and are faster than sending
data in ASCII format.
binary formats can be sent over parallel or serial communications ports and are faster than sending
data in ASCII format.
Send Ctrl-D Before Each Job
This control specifies whether the product will be reset at the beginning of every postscript
document. The default setting is No. Ctrl-D resets the product to its default setting to ensure that
previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail if the
product is connected through a network. If your document fails to print when sent to a product
connected through parallel or serial ports, change No to Yes.
document. The default setting is No. Ctrl-D resets the product to its default setting to ensure that
previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail if the
product is connected through a network. If your document fails to print when sent to a product
connected through parallel or serial ports, change No to Yes.
HP traditional Postscript 3 Emulation Driver features
173