HP laserjet 3390, 3392 all-in-one Manuale Di Servizio
Duplex assembly
1.
Remove the following components.
●
Right cover. See
●
Left cover. See
.
●
Rear cover. See
.
2.
Push down on the green lever at the front of the all-in-one to unlock and lower the duplex assembly.
Figure 5-48
Remove the duplex assembly (1 of 3)
3.
Use a small flatblade screwdriver to release the locking tab on the duplex assembly hinge (the tab
is behind the LIU). Rotate the hinge toward the front of the front of the all-in-one until the tabs on
the hinge align with the slots in the chassis, and then remove the hinge.
is behind the LIU). Rotate the hinge toward the front of the front of the all-in-one until the tabs on
the hinge align with the slots in the chassis, and then remove the hinge.
1
2
3
Figure 5-49
Remove the duplex assembly (2 of 3)
146
Chapter 5 Removal and replacement
ENWW