HP laserjet 3390, 3392 all-in-one Manuale Di Servizio
7.
Remove one screw (callout 8) and release one clip (callout 9) on the wire guide that contains the
optional tray 3 connector.
optional tray 3 connector.
NOTE
It is not necessary to remove the tray 3 connector or the wire-harness guide. But
you need to release the guide so that the tray 3 connector wire-harness is loose enough to
be removed from a guide on the fuser later in this procedure.
be removed from a guide on the fuser later in this procedure.
9
8
Figure 5-64
Remove the fuser (6 of 11)
8.
Disconnect one connector (callout 10) and then remove the wire-harness from the guide.
NOTE
Before you proceed to the next step, make sure that all of the wire-harnesses that
you disconnected in previous steps have been released from any wire-harness guides and
holders.
holders.
10
Figure 5-65
Remove the fuser (7 of 11)
160
Chapter 5 Removal and replacement
ENWW