HP laserjet 1018 Manuale Di Servizio

This section includes five functional checks for troubleshooting.

The print process can be subdivided into the following stages:

●

Image-formation stage (charges the drum and writes a latent image to the drum with the laser)

●

Development stage (forms a toner image on the drum)

●

Transfer stage (transfers the image to media)

●

Cleaning stage (removes excess toner from the drum)

●

Fusing stage (applies heat and pressure to make the image permanent on the media)

The purpose of the half self-test check is to begin the printing process and then interrupt it in the
middle. Examining the printer components at that point allows you to determine which stage in the
print process is malfunctioning.

Open the Printer Properties dialog box. Select Print Test Page to print a test page. Click OK
to close the HP LaserJet 1018 test page troubleshooting dialog box. Click OK again to close
the Printer Properties dialog box.

Open the print-cartridge door the instant the leading edge of the paper exits the printer.

Remove the print cartridge.

Open the print cartridge drum shield to view the drum surface. If a dark and distinct toner image
is present on the drum surface, then the first two functions of the electrophotographic process
are functioning (image-formation and development). Any failure is occurring in the transfer or
fusing stage.

If no image appears on the photosensitive drum, perform these checks:

Make sure that you remove the entire length of the sealing tape from the print cartridge before
you install the cartridge. If the tape is not removed, then toner cannot reach the drum.

Perform a drum-rotation functional check to ensure that the drum is rotating (see 

Perform a high-voltage contact check (see 

).

ENWW

Functional checks

107