HP laserjet 1018 Manuale Di Servizio
Cleaning the print path
The HP LaserJet 1018 printer features a special cleaning mode to clean the paper path.
NOTE
This process requires using a transparency to remove dust and toner from the print
paper path. Do not use bond or rough paper.
Make sure that the transparency that is used in this cleaning process meets the media
requirements for the printer.
requirements for the printer.
If transparency film is unavailable, use copier-grade paper (70 to 90 g/m
2
, or 18 to 24 lb) that
has a smooth surface. If you must use paper, perform the procedure two or three times to
ensure thorough cleaning.
ensure thorough cleaning.
1.
Make sure that the printer is idle and the
Ready
light is on.
2.
Load the media in the input tray.
3.
Open the Printer Properties dialog box.
4.
Click the Configure tab, and then select Start in the Cleaning Page box.
5.
Follow the instructions in the Cleaning Utility dialog box.
NOTE
The cleaning process takes approximately 3 minutes. The cleaning page stops
periodically during the cleaning process. Do not turn the printer off until the cleaning process
has been completed. You might need to repeat the cleaning process several times to
thoroughly clean the printer.
has been completed. You might need to repeat the cleaning process several times to
thoroughly clean the printer.
Cleaning the print-cartridge area
You do not need to clean the print-cartridge area often. However, cleaning this area can improve the
quality of printed sheets.
quality of printed sheets.
1.
Turn off the printer, unplug and remove the power cord. Wait for the printer to cool.
26
Chapter 3 Maintenance
ENWW