HP ml350 Manuale Utente
Removal and replacement procedures 37
o
Unlock and remove the bezel ("
o
Extend the server from the rack (on page
3.
Remove the access panel.
4.
Remove the air baffle.
To replace the component, reverse the removal procedure.
System fans
CAUTION:
The system fan is a non-hot-pluggable device.
Fan failures are indicated by amber LEDs located on each hot-plug fan and by the front panel internal
health LED. When a fan failure occurs, the internal health LED illuminates red in non-redundant mode and
amber in redundant mode.
To remove the component:
To remove the component:
1.
Power down the server (on page
2.
Do one of the following:
o
Unlock and remove the bezel ("
o
Extend the server from the rack (on page
3.
Remove the access panel.
4.
Remove the air baffle ("
5.
Disconnect the system fan cable from the system board.