HP lp145n Manuale Utente
Printer Does Not Print
101
8
Printer Does Not Print
If printing still does not start, contact your sales or service representative. Con-
sult with the store where the printer was purchased for information about the
location of sales or service representatives.
sult with the store where the printer was purchased for information about the
location of sales or service representatives.
Possible Cause
Solutions
Is the power on?
Confirm that the cable is securely plugged into the power outlet
and the printer.
and the printer.
Turn on the power.
Does the Online indicator
stay on?
stay on?
If not, press the {Online} key to light it.
Does the Alert indicator
stay red?
stay red?
If so, check the error message on the display and take the required
action.
action.
Is paper loaded?
Load paper into the paper tray or onto the bypass tray.
Can you print a configura-
tion page?
tion page?
If you cannot print a configuration page, it probably indicates a
printer malfunction. Contact your sales or service representative.
printer malfunction. Contact your sales or service representative.
See “Printing the Test Page”, Quick Installation Guide.
Is the interface cable con-
nected securely to the
printer and the computer?
nected securely to the
printer and the computer?
Connect the interface cable securely. If it has a fastener, fasten it
securely as well.
securely as well.
Are you using the correct
interface cable?
interface cable?
The type of interface cable you should use depends on the compu-
ter you use. Be sure to use the correct one.
ter you use. Be sure to use the correct one.
If the cable is damaged or worn, replace it with a new one.
Is the Data In indicator
blinking or lit after starting
the print job?
blinking or lit after starting
the print job?
If not blinking or lit, the data is not being sent to the printer.
❖ If the printer is connected to the computer using the in-
terface cable
Check the port connection setting is correct. For details about
checking the port connection, see p.102 “Checking the port
connection”.
checking the port connection, see p.102 “Checking the port
connection”.
❖ Network Connection
Contact your network administrator.
How is the signal strength
when using the wireless
LAN?
when using the wireless
LAN?
❖ Ad hoc Mode or 802.11 Ad hoc Mode
Either move to a location where the signal is good, or remove
obstructions.
obstructions.
❖ Infrastructure Mode
Check the signal status from the “Maintenance” menu on the
control panel. If the signal is poor, either move to a location
where it is good, or remove obstructions.
control panel. If the signal is poor, either move to a location
where it is good, or remove obstructions.