HP lp145n Manuale Utente
IEEE 802.11b (Wireless LAN) Configuration
57
4
IEEE 802.11b (Wireless LAN) Configuration
Configure the printer to use IEEE 802.11b (Wireless LAN). The following table
shows the control panel settings and their default values. These items appear in
the [Host Interface] menu.
shows the control panel settings and their default values. These items appear in
the [Host Interface] menu.
Important
❒ For using the IEEE 802.11b interface unit, installing the optional SDRAM
module is required. If the optional SDRAM module is not installed, the print-
er does not detect the unit, and also it does not function because of memory
shortage.
er does not detect the unit, and also it does not function because of memory
shortage.
❒ To use IEEE 802.11b (Wireless LAN), set as the followings using the control
panel: press the {Menu} key, and then select [Host Interface], [Network Setup],
[LAN Type], and then [IEEE 802.11b]. Also, set the IP Address, Subnet Mask,
Gateway Address, DHCP, Frame Type (NW), and Active Protocol under the
[Network Setup]
[LAN Type], and then [IEEE 802.11b]. Also, set the IP Address, Subnet Mask,
Gateway Address, DHCP, Frame Type (NW), and Active Protocol under the
[Network Setup]
menu. For details about setting items, see “Configuring the
Printer for the Network”, Software Guide.
❒ The 802.11b interface unit cannot be used simultaneously with a standard
ethernet interface.
A
Press the {Menu} key.
Setting Name
Default Value
Communication Mode
802.11 Ad hoc
Channel
•
(1-11) 11
•
(1-13) 13
Communication Speed
Auto
SSID
blank
WEP
Not Active
AQV251S