HP photosmart pro b8800 series Manuale Utente
Solution: Wait while the software finishes copying files; this might take several minutes. If, after several
minutes, the computer is still not responding, restart the computer, pause or disable any active virus protection
software, quit all other software programs, and then reinstall the printer software.
minutes, the computer is still not responding, restart the computer, pause or disable any active virus protection
software, quit all other software programs, and then reinstall the printer software.
Printer hardware setup problems
If you are having problems related to printer hardware setup, check this section for possible solutions. If your issue
is related to software setup, see
is related to software setup, see
. If any of the indicator lights on the printer
control panel are flashing, see
for more information.
NOTE: For complete troubleshooting assistance on printer setup, see the animated Quick Start Tutorial on the
HP Photosmart software CD. To view the Tutorial, follow these steps:
HP Photosmart software CD. To view the Tutorial, follow these steps:
Windows: Insert the CD into your computer and click View Quick Start Tutorial.
Mac: Insert the CD into your computer, double-click the HP Software icon, and then double-click the HP
Installer icon.
Installer icon.
The animated Quick Start Tutorial on the CD provides instructions for setting up the printer and installing software
along with troubleshooting information. To access the troubleshooting information, click Need help? on the
bottom-left corner of the Quick Start Tutorial screen.
along with troubleshooting information. To access the troubleshooting information, click Need help? on the
bottom-left corner of the Quick Start Tutorial screen.
The printer is plugged in but will not turn on
Solution
•
•
The printer might have drawn too much power. Unplug the printer power cord from the back of the printer.
Wait about 30 seconds, and then plug the cord back in. Turn on the printer.
Wait about 30 seconds, and then plug the cord back in. Turn on the printer.
•
The printer might be plugged into a power strip that is turned off. Turn on the power strip, and then turn on
the printer.
the printer.
•
The power cord could be defective.
I do not know where to insert the printheads
Solution: Make sure the blue printhead assembly cover is open all the way. Pull the blue handle forward to
unlatch it, and then raise the cover all the way. The printhead slots will then be visible. For more information,
see the Insert the printheads section of the animated Quick Start Tutorial.
unlatch it, and then raise the cover all the way. The printhead slots will then be visible. For more information,
see the Insert the printheads section of the animated Quick Start Tutorial.
I cannot remove the output tray
Solution
•
•
Pull the output tray straight towards you. Do not lift the forward edge upwards as you pull. It may take some
force to pull the tray out.
force to pull the tray out.
•
Make sure you are not pulling the main tray (beneath the output tray) as you pull the output tray out.
Nothing happens when I press the Resume button
Solution: Make sure all four printheads and all eight ink cartridges are installed correctly. Check that both
doors and the specialty media tray are closed. Wait for the Resume light to start flashing quickly, and then try
pressing the Resume button again. If the printer calibration does not begin, there might be a paper jam. For
more information on clearing paper jams, see
doors and the specialty media tray are closed. Wait for the Resume light to start flashing quickly, and then try
pressing the Resume button again. If the printer calibration does not begin, there might be a paper jam. For
more information on clearing paper jams, see
.
Chapter 5
30
Troubleshooting and support
E
n
glish