HP photosmart 2700 Manuale Utente

Media in another tray is the same size as the transparencies
or glossy paper, and the printer is defaulting to the other tray.

Make sure that the tray that contains the transparencies or
glossy paper is selected in the software program or printer
driver. Use the printer control panel to configure the tray to the
type that is loaded. See 

.

The tray that contains the transparencies or glossy paper is not
configured correctly for type.

Make sure that the tray that contains the transparencies or
glossy paper is selected in the software program or printer
driver. Use the printer control panel to configure the tray to the
type that is loaded. See 

.

Envelopes are loaded in an unsupported tray.

Load envelopes into tray 1.

Envelopes are curled or damaged.

Try using different envelopes. Store envelopes in a controlled
environment. See 

 for more information.

Envelopes are sealing because the moisture content is too
high.

Try using different envelopes. Store envelopes in a controlled
environment.

The envelope orientation is incorrect.

Verify that the envelope is loaded correctly. See 

.

This printer does not support the envelopes.

See 

 or the HP LaserJet Printer

Family Print Media Specification Guide.

The tray is configured for a size other than envelopes.

Configure the tray size for envelopes.

The media does not meet the specifications for this printer.

Use only media that meets the HP specifications for this
printer. See 

The media is damaged or in poor condition.

Remove the media from the tray and load media that is in good
condition.

The printer is operating in an excessively humid environment. Verify that the printing environment is within humidity

specifications.

You are printing large, solid-filled areas.

Large, solid-filled areas can cause excessive curl. Try using a
different pattern.

The media was not stored correctly and may have absorbed
moisture.

Remove the media and replace it with media from a fresh,
unopened package.

The media has poorly cut edges.

Remove the media, flex it, rotate it 180 degrees, or turn it over,
and then reload it into the tray. Do not fan paper. If the problem
persists, replace the paper.

The specific media type was not configured for the tray or
selected in the software.

Configure the software for the media (see the software
documentation). Configure the tray for the media. See

.

ENWW

Paper-handling problems

109