HP photosmart 2700 Manuale Utente
If your software does not automatically format an envelope, specify Landscape for page orientation in
the software program. Use the guidelines in the table that follows to set margins for return and destination
addresses on Commercial #10 or DL envelopes.
the software program. Use the guidelines in the table that follows to set margins for return and destination
addresses on Commercial #10 or DL envelopes.
Address type
Left margin
Top margin
Return
15 mm (0.6 inch)
15 mm (0.6 inch)
Destination
102 mm (4.0 inch)
51 mm (2.0 inch)
Labels
●
In either the software program or the printer driver, select Labels as the media type, or configure
tray 1 or tray 2 for labels. See
tray 1 or tray 2 for labels. See
●
Verify that the labels’ adhesive material can tolerate temperatures of 190°C (374°F) for 0.1 second.
●
Verify that there is no exposed adhesive material between the labels. Exposed areas can cause
labels to peel off during printing, which can cause paper jams. Exposed adhesive can also cause
damage to printer components.
labels to peel off during printing, which can cause paper jams. Exposed adhesive can also cause
damage to printer components.
●
Do not re-feed a sheet of labels.
●
Verify that labels lie flat.
●
Do not use labels that are wrinkled, bubbled, or otherwise damaged.
Heavy paper
●
For information about which heavy paper is supported in each tray, see
●
In either the software program or the printer driver, select Heavy or Cardstock as the media type,
or print from a tray that is configured for heavy paper. Because this setting affects all print jobs, it
is important to return the printer back to its original settings after the job has been printed. See
or print from a tray that is configured for heavy paper. Because this setting affects all print jobs, it
is important to return the printer back to its original settings after the job has been printed. See
CAUTION
In general, do not use paper that is heavier than the media specification
recommended for this printer. Doing so can cause misfeeds, jams, reduced print quality, and
excessive mechanical wear.
excessive mechanical wear.
Preprinted forms and letterhead
●
Forms and letterhead must be printed with heat-resistant inks that will not melt, vaporize, or release
hazardous emissions when subjected to the printer’s fusing temperature of approximately 190°C
(374°F) for 0.1 second.
hazardous emissions when subjected to the printer’s fusing temperature of approximately 190°C
(374°F) for 0.1 second.
●
Inks must be nonflammable and should not adversely affect any printer rollers.
●
Forms and letterhead should be sealed in a moisture-proof wrapping to prevent changes during
storage.
storage.
●
Before loading preprinted paper, verify that the ink on the paper is dry. During the fusing process,
wet ink can come off of preprinted paper.
wet ink can come off of preprinted paper.
ENWW
Printing on special media
15