HP procurve 2500 Manuale Utente

221    

•

Running configuration has been changed and needs to be saved.
This message indicates that the two configurations are different. 

Change in CLI Command for Listing Intrusion Alerts

With port security configured, the switch formerly used 

show interfaces to display a port status listing 

that includes intrusion alerts (as described on page 7-28 in the manual). The show interfaces 
command now lists other port data  (see below) and the command for listing port status with intrusion 
alerts is now 

show interfaces brief. 

Changes for Listing Port and Trunk Group Statistics

The Port Counters screen in the Menu interface now includes flow control and broadcast limit data 
for each port.

The switch formerly used the 

show statistics [e] < port-list > to display port counter information (page 

10-10). The command is now 

show interfaces [e] < port-list >. (The show statistics [e] < port-list> 

command is now obsolete.   

Time Protocol Changes

Because the switch now offers both TimeP and SNTP (Simple Network Time Protocol) as time 
synchronization methods, the TimeP configuration information on pages 5-3 through 5-10 has 
changed. See “Enhancements in Release F.02.02” on page 164.

Change in Command Line (CLI) Operation

For the (port) Interface and VLAN commands, the command line accepts only one parameter at a 
time. For example, for port 1, you would use either of the following two command sets to configure 
duplex, flow control, and broadcast limit (instead of combining them all in one command).

At the Interface Context Level

HP2512(eth-1)# enable speed-duplex auto

HP2512(eth-1)# enable flow-control

HP2512(eth-1)# enable broadcast-limit 50

At the Global Configuration Level

HP2512(config)# int e 1 enable speed-duplex auto

HP2512(config)# int e 1 enable flow-control

HP2512(config)# int e 1 enable broadcast-limit 50