HP procurve 2500 Manuale Utente

Pagina di 270
    246
Software Fixes
SNMP —
 The OID ifAlias is defaulted to "not assigned", causing Network Node Manager to 
log error messages. (The fix is to default ifAlias to a zero-length string, as stated in the MIB, 
or make each port have a unique value.)
SNMP —
 The switch does not support community names other than PUBLIC in traps.
SNMP/Crash —
 A walkmib of the cdpCacheDeviceId OID using an ifIndex value of the 
Default VLAN causes the switch to crash with a bus error similar to:
-> Bus error:  HW Addr=0x5265766d IP=0x002592e8 Task='mSnmpCtrl'
   Task ID=0x12c2158 fp: 0x00000005 sp:0x012c1e28 lr:0x00259430
STP —
 Under some conditions, an 802.1w non-Root switch will have a zero Root Path Cost. 
TACACS+ — 
 The TACACS server IP is shown on the 'splash screen'.
TELNET —
 TCP port 1506 is always open.
UI — 
In the absence of a time server, the switch may report that it is the year "26".
Web — 
Web browser port utilization pop-up does not display the bandwidth number. Shows 
x% of 0Mb instead of x% of 100Mb or x% of 1Gb.
Web/Security —
 When a 2500 series switch is acting as an IP Stack Commander, it is possible 
to send a specific command to the 2500’s WEB agent that will inappropriately reset an IP 
Stack Member switch. 
Web/Security —
 
1. Set Series 2500 switch as commander of a stack containing only one 
    1600M/2400M/2424M/4000M/8000M switch member.
2. Send the following URL to the Series 2500 switch (Commander):
http://<IP ADDRESS>/sw2/cgi/device_reset?
This will cause the member switch to reboot, even without a password on the    commander 
(password not allowed on a member).
Release F.05.16 
(Beta Release Only)
Fixed in release F.05.16
IP Stack Mgmt/Web —
 A bus error occurs when accessing the close-up view of a 15-member 
stack (IP Stack Management) through the Web interface.
LACP —
 With a 2500-Series switch linked via SX or LX to 5300-Series switch, turn off LACP 
on the 2500 when RSTP is enabled, and STP's status becomes disabled on that port. 
LACP —
 With a 2500-Series switch linked via SX or LX to a 5300-Series switch, turn off LACP 
on the 2500 when RSTP is enabled, and STP's status becomes disabled on that port.