HP procurve 2500 Manuale Utente

Enhancements in Release F.05.05 through F.05.70
Enhancements in Release F.05.05 through F.05.60

4. Enter the RADIUS Host IP Address(es)

If you selected either

eap-radius or chap-radius for the authentication method, configure the switch

to use 1 to 3 RADIUS servers for authentication. The following syntax shows the basic commands.
For coverage of all commands related to RADIUS server configuration, refer to “Configuring RADIUS
Authentication and Accounting” on page -102.

5. Enable 802.1X Authentication on the Switch

After configuring 802.1X authentication as described in the preceding four sections, activate it with
this command:

Syntax:

radius host < ip-address >

Adds a server to the RADIUS configuration

[key < server-specific key-string >]

Optional. Specifies an encryption key for use during
authentication (or accounting) sessions with the spec-
ified server. This key must match the key used on the
RADIUS server. Use this option only if the specified
server requires a different key than configured for the
global encryption key.

radius-server key < global key-string >

Specifies the global encryption key the switch uses for
sessions with servers for which the switch does not have
a server-specific key. This key is optional if all RADIUS
server addresses configured in the switch include a
server- specific encryption key.

Syntax:

aaa port-access authenticator active

Activates 802.1X port-access on ports you have configured
as authenticators.