HP psc 1200 Manuale Utente

reference guide

get hp psc support

35

If after contacting HP Customer Support or returning to the point of purchase, 
you are requested to send your unit in for service, please follow the power off 
and rebox steps below to avoid further damage to the HP product.

Note: When transporting your HP PSC, make sure that the pens have been 
removed, the HP PSC has been properly shut down by pressing the power 
button, and you have allowed time for the carriage to return to the service 
station and for the scanner to return to its parked position.

Turn on the unit.
Disregard steps 1 through 5, if your unit will not turn on and the print 
carriage is in the home position. You will not be able to remove the print 
cartridges. Proceed to step 6.

Open the print-carriage access door.
The print carriage moves to the center of the unit.

Caution! Remove both print cartridges. Failure to do so may 
damage your unit.

See replace the print cartridges on page 23 for information on removing 
the print cartridges.

Place the print cartridges in an airtight bag so they will not dry out, and 
put them aside (do not send them with the unit, unless instructed to by the 
HP customer support call agent).

Close the print cartridge access door.

Wait for the print cartridge to park (stop moving). This may take a few 
seconds.

Turn off the unit.

If available, pack the unit for shipment using the original packing 
materials or the packaging materials that come with your exchange unit.

If you do not have the original packaging materials, please use other 
adequate packaging materials. Shipping damage caused by improper 
packaging and/or improper transportation is not covered under the 
warranty.