HP qms 4060 Manuale Utente
Configuration
Menu
QMS 4060 Print System Reference
4-4
ronment. To avoid confusion in a shared printing environment, only
the system administrator should make configuration changes. See
the QMS CrownAdmin on-line help for information on using Remote
Console.
the system administrator should make configuration changes. See
the QMS CrownAdmin on-line help for information on using Remote
Console.
»
Note:
If a remote console has the printer off line, pressing the Online
button will not take effect until the console puts the printer back on
line.
line.
Using the Local Console Port
The Local Console port can also allow you to make configuration
choices that are normally made at the control panel. See chapter 6,
“Local and Remote Console,” of the
choices that are normally made at the control panel. See chapter 6,
“Local and Remote Console,” of the
Operations manual for more
information.
»
Note:
If a local console has the printer off line, pressing the Online
button will not take effect until the console puts the printer back on
line.
line.
Configuration Menu
The printer’s configuration menu allows you to change the default
printer configuration settings. Any changes made to the configuration
will reside as new default settings and affect all subsequent print jobs.
printer configuration settings. Any changes made to the configuration
will reside as new default settings and affect all subsequent print jobs.
The options in the configuration menu are organized under three
main menus:
main menus:
n
Operator Control Menu
Use this menu to select document processing options such as
copy count, choosing input and output paper bins, chaining input
bins, and duplexing (if a duplexing unit is installed). Document
processing options are usually specified within individual jobs
since each job has its own requirements. However, if there’s no
way of specifying these options within an application, use the
control panel to change options, send the job, and then change
the defaults back.
copy count, choosing input and output paper bins, chaining input
bins, and duplexing (if a duplexing unit is installed). Document
processing options are usually specified within individual jobs
since each job has its own requirements. However, if there’s no
way of specifying these options within an application, use the
control panel to change options, send the job, and then change
the defaults back.