HP qms 1660e Manuale Utente
Memory
4-49
Printer Configuration
Frame Buffer
The Frame Buffer memory client holds rasterized or bitmapped
images of page faces which are ready to be sent to the print engine.
A frame holds the contents of each single page image.
images of page faces which are ready to be sent to the print engine.
A frame holds the contents of each single page image.
If you are uncertain about how to configure your printer’s memory,
use only the Administration/Memory/Frame Buffer menu. Or use this
menu as a starting point before trying manually to configure your
printer’s memory. It provides a simple method of defining how much
memory should go to each of the clients for the most complicated
printing conditions in your environment. Menu options allow you to
specify the largest media size you plan to use for each resolution.
Memory is then automatically allocated to the clients that require it.
Any excess memory is allocated to the excess memory client. See
chapter 5, “Additional Technical Information,” for more information on
memory and the frame buffer client.
use only the Administration/Memory/Frame Buffer menu. Or use this
menu as a starting point before trying manually to configure your
printer’s memory. It provides a simple method of defining how much
memory should go to each of the clients for the most complicated
printing conditions in your environment. Menu options allow you to
specify the largest media size you plan to use for each resolution.
Memory is then automatically allocated to the clients that require it.
Any excess memory is allocated to the excess memory client. See
chapter 5, “Additional Technical Information,” for more information on
memory and the frame buffer client.
Notes
If disk swapping is enabled and the system hard disk is
removed or not turned on, the printer automatically resets to
the factory defaults. It is then necessary to re-enable disk
swapping if you want this functionality.
removed or not turned on, the printer automatically resets to
the factory defaults. It is then necessary to re-enable disk
swapping if you want this functionality.
Before you install printer options, such as fonts and macros,
ensure that the printer has enough memory, or they may not all
be available for use. If it doesn’t, you can install SIMMs (see
chapter 6, “Printer Options”) to increase printer memory, or you
can install a hard disk (see chapter 6, “Printer Options”) and
enable disk swapping.
ensure that the printer has enough memory, or they may not all
be available for use. If it doesn’t, you can install SIMMs (see
chapter 6, “Printer Options”) to increase printer memory, or you
can install a hard disk (see chapter 6, “Printer Options”) and
enable disk swapping.
The printer must be restarted for changes to the Enable Disk
Swap menu to take effect. You can either let the printer restart
automatically after you save the change and exit from the
configuration menu, or you can wait for the change to take
effect the next time you manually turn on the printer.
Swap menu to take effect. You can either let the printer restart
automatically after you save the change and exit from the
configuration menu, or you can wait for the change to take
effect the next time you manually turn on the printer.
If you enable disk swapping and restart the printer, the disk
cache size automatically increases to 256 KB.
cache size automatically increases to 256 KB.