HP qms 1660 Manuale Utente
Storage
Options
6-49
Printer Options
3
Remove the screws securing the IDE-SCSI board to the rear
interface panel of the printer.
interface panel of the printer.
Save the screws. (You’ll use them when you reinstall the board.)
4
Remove the IDE-SCSI board from the plastic standoff and the
80-pin connector on the controller board.
80-pin connector on the controller board.
To unlock the standoff, squeeze the tip between two fingers until
you can easily remove the board.
you can easily remove the board.
5
Install the internal hard disk.
n
If you’re installing an internal hard disk for the first time, use
the instructions in a following section, “Installing an Internal
Hard Disk.”
the instructions in a following section, “Installing an Internal
Hard Disk.”
n
If you’re removing an internal hard disk at this time (for exam-
ple, if you are removing an IDE hard disk to install a Kanji IDE
hard disk), use the instructions in a following section,
“Removing an Internal Hard Disk,” and then use the instruc-
tions in the “Installing an Internal Hard Disk” section.
ple, if you are removing an IDE hard disk to install a Kanji IDE
hard disk), use the instructions in a following section,
“Removing an Internal Hard Disk,” and then use the instruc-
tions in the “Installing an Internal Hard Disk” section.
Internal IDE Hard Disk
The internal IDE hard disk is identified by the hard disk device num-
ber DSK7.
ber DSK7.
IDE Hard Disk Assembly Kit
The IDE hard disk assembly kit includes the following:
n
IDE hard disk
n
Plastic ribbon cable
n
4 screws
Installing an Internal IDE Hard Disk
Only one internal IDE hard disk is supported. However, you can add
up to three external SCSI hard disks to the printer.
up to three external SCSI hard disks to the printer.