Canon iP5200 Manuale Utente

 

21

f)     Adjustments to the tube length may be required. To check this, move the 

cartridge holder left and right to each end of the printer. It should reach both 
ends with ease. Check that the tubing is neither too long nor too short. The 
tubing must not interfere with the printer data wire nor should it fall down into 
the paper support or cause any interference to the head movement. 

 

   

 

  

 

g)  If required, adjust the tube length by gently pulling the silicone tubing in the 

direction required. 

h)  As the scanner lid is being held ajar by an extra centimetre it may be necessary 

to activate the lid sensor switch.  Cut a small piece of Styrofoam (around 1cm

2) 

from the CISS packaging.  Use the foam to push down and activate the lid 
sensor located at the right hand corner of the printer as pictured below.