Nikon DS-2MBWC Manuale Utente

 

VI Basic Operations 

 

MICROSCOPE 

 

 

6  Using the Microscope Control 

- 143 - 

NOTE: 
* 

When you are using a microscope incorporating the DIH-M, only the current 
optical path is displayed. 

* 

Each time you left-click to select, the optical path changes sequentially from 
Binocular to Front port and Rear port and back to Binocular. When you 
right-click to select, the optical path changes sequentially from Binocular to 
Rear port and Front port and back to Binocular. 

* 

If you change the optical path, AE is locked unless the port to which the 
camera head is connected has been set to be enabled. 

* 

If the rear port illumination is supplied at 30%/70% from a connected 
DIH-M, the icon will change to indicate that the optical path has been 
switched to the rear port                  . 
 

 

 

When you are using the DIH, the camera head can be connected to the front port and rear port. 
With default settings, the camera head is connected to the rear port. If you want the camera 
head connected to the front port when you use it, select the check box 

 (by putting 

a check mark in it). 

 

NOTE: 
* 

The F_Port check box is displayed only when the connected microscope 
incorporates the DIH-M or DIH-E. 

* 

When the DS-L1 is used with the front port, you will see the message 
"None" displayed in the Zoom column of the "microscope control menu 1" 
and the "microscope status display/microscopy setup menu" (MIC Info 
menu). 

* 

Information on the selected port to which the camera head is connected is 
retained even after power to the camera head is turned off. The saved 
settings take effect the next time the power to the camera head is turned 
on. 

 

Compatible only with microscope incorporating the DIH. 

 

1）  Select the shutter change icon for episcopic illumination use to change the open/closed 

status of the shutter. 

2）  The current status is indicated by a picture depicting the shutter change icon. ( 

 when 

closed, 

 when open) 

 

 

 

 

 

 

 

 

 

Compatible only with microscope incorporating the DIH-E. 

 

1）  In the filter column 

, select the filter number to which your desired filter cube is 

registered. The filter cubes will change to the one that you've selected.