Sony BDP-S190 Manuale Utente

, Check that [Control for HDMI] is set 

to [On] (page 22).

, If you change the HDMI connection, 

turn the player off and on again.

, If power failure occurs, set [Control 

for HDMI] to [Off], then set [Control 
for HDMI] to [On] (page 22).

, Check the following and refer to the 

instruction manual supplied with the 
component.
– the connected component is 

compatible with the [Control for 
HDMI] function.

– the connected component’s setting 

for the [Control for HDMI] function 
is correct.

, When you connect the player to a TV 

through an AV amplifier (receiver), 
– if the AV amplifier (receiver) is not 

compatible with the [Control for 
HDMI] function, you may be unable 
to control the TV from the player.

– if you change the HDMI 

connection, disconnect and 
reconnect the AC power cord 
(mains lead), or a power failure 
occurs, try the following: 

1

Switch 

the input selector of the AV 
amplifier (receiver) so that the 
picture from the player appears on 
the TV screen. 

2

Set [Control for 

HDMI] to [Off], then set [Control 
for HDMI] to [On] (page 22). Refer 
to the instruction manual supplied 
with the AV amplifier (receiver).

, Check that [Control for HDMI] and 

[HDMI:Linked to TV-off] are set to 
[On] (page 22).

, Press OPTIONS, and select [Play from 

start].

, The resume point may be cleared from 

memory depending on the disc when
– you open the disc tray.
– you disconnect the USB device.
– you play other content.
– you turn off the player.

The disc tray does not open and you 
cannot remove the disc even after you 
press Z.

, Try the following: 

1

Turn the player 

off, and disconnect the AC power cord 
(mains lead). 

2

Reconnect the AC 

power cord (mains lead) while 
pressing down Z on the player. 

3

Keep pressing down Z on the player 

until the tray opens. 

4

Remove the 

disc. 

5

Hold down [/1 on the player 

for more than 10 seconds until the 
player turns off.