Sony DCR-HC22E Manuale Utente

DCR-HC17E/HC19E/HC21E/HC22E 2-586-501-11(1)

The position of the “×” changes. If you did 
not press the right spot, start from step 



 

again.

•  You cannot calibrate the LCD screen if it is 

rotated.

•  If the casing is soiled, clean the camcorder body 

with a soft cloth lightly moistened with water, 
and then wipe the casing with a dry soft cloth.

•  Avoid the following to avoid damage to the 

finish.
–  Using chemicals such as thinner, benzine, 

alcohol, chemical cloths, repellent and 
insecticide.

–  Handling with above substances on your 

hands.

–  Leaving the casing in contact with rubber or 

vinyl objects for a long period of time.

•  Wipe the surface of the lens clean with a soft 

cloth in the following instances:
–  When there are fingerprints on the lens 

surface.

–  In hot or humid locations
–  When the lens is exposed to salty air such as 

at the seaside.

•  Store in a well-ventilated location subject to 

little dirt or dust.

•  To prevent mold, periodically clean the lens as 

described above. It is recommended that you 
operate your camcorder about once a month to 
keep it in optimum state for a long time.

Your camcorder has a pre-installed 
rechargeable battery to retain the date, 
time, and other settings even when the 
POWER switch is set to OFF (CHG). 
The pre-installed rechargeable battery 
is always charged while you are using 
your camcorder but it will get discharged 
gradually if you do not use your camcorder. 
The rechargeable battery will be fully 
discharged in about 3 months if you do not 
use your camcorder at all. However, even if 
the pre-installed rechargeable battery is not 

charged, the camcorder operation will not 
be affected as long as you are not recording 
the date.



Connect your camcorder to a wall socket 
using the supplied AC Adaptor, and leave it 
with the POWER switch set to OFF (CHG) 
for more than 24 hours.



  While pressing on the tab, inset your 

fingernail into the slit to pull out the 
battery case.



  Place a new battery with the + side facing 

up.



  Insert the battery case back into the 

Remote Commander until it clicks. 

Tab

Battery may explode if mistreated. Do not 
recharge, disassemble or dispose of in fire.

Danger of explosion if battery is 
incorrectly replaced. Replace only with 
the same or equivalent type recommended 
by the manufacturer.
Discard used batteries according to the 
manufacturer’s instructions.

•  A button-type lithium battery (CR2025) is used 

in the Remote Commander. Do not use batteries 
other than the CR2025.

•  When the lithium battery becomes weak, the 

operating distance of the Remote Commander 
may shorten, or the Remote Commander may 
not function properly. In this case, replace the 
battery with a Sony CR2025 lithium battery. 
Use of another battery may present a risk of fire 
or explosion.