Sony HTSS370 Manuale Utente

 

 

 

 

 

 

 

• Use a 75-ohm coaxial cable (not supplied) 

to connect the receiver to an outdoor FM 
antenna (aerial) as shown below. If you 
connect the receiver to an outdoor antenna 
(aerial), ground it against lightning. To 
prevent a gas explosion, do not connect the 
ground wire to a gas pipe.

• Check that the antennas are connected 

securely. Adjust the antennas and connect 
an external antenna (aerial), if necessary.

• The signal strength of the stations is too 

weak (when tuning in with automatic 
tuning). Change to monaural reception 
(page 35).

• No stations have been preset or the preset 

stations have been cleared (when tuning 
by scanning preset stations). Preset the 
stations (page 37).

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

• Contact the radio station and find out 

whether they actually provide the service 
in question. If so, the service may be 
temporarily out of order.

* Models of area code CEL only.

• Point the remote at the remote sensor on 

the receiver.

• Remove any obstacles in the path between 

the remote and the receiver.

• Replace all the batteries in the remote with 

new ones, if they are weak.

• Make sure you select the correct input on 

the remote.

• The receiver is in protection mode. Turn 

off the receiver and turn it on again.

• The AUTO STBY function is working 

AM

Receiver

To ground

Ground wire 
(not supplied) 

Outdoor FM antenna (aerial)