Sony MDS-E10 Manuale Utente
8
Location and Function of Parts
12
678
3 4 5
VOLTAGE
SELECTOR
230V
120V
9
1 ANALOG (UNBALANCE) input jacks
Inputs as an analog signal the sound of the component
connected by a pin type connecting cable.
connected by a pin type connecting cable.
2 ANALOG (UNBALANCE) output jacks
Outputs as an analog signal the contents of the MD of
this recorder to the component connected by a pin type
connecting cable.
this recorder to the component connected by a pin type
connecting cable.
3 ANALOG INPUT LEVEL control
Can adjust the level of analog input in a range of _
∞
~
+15 dB.
Normally, this control is used in the position (0 dB) of
center click.
Normally, this control is used in the position (0 dB) of
center click.
4 DIGITAL COAXIAL input jack
Inputs as a digital signal the sound of the connected
component.
component.
5 DIGITAL COAXIAL output jack
Outputs an a digital signal the contents of the MD of
the recorder to the connected component.
the recorder to the connected component.
6 DIGITAL OPTICAL input connector
Inputs as a digital signal the sound of the connected
component.
component.
7 DIGITAL OPTICAL output connector
Outputs an a digital signal the contents of the MD of
the recorder to the connected component.
the recorder to the connected component.
8 CONTROL-S jack
Connects the remote or control equipment.
If the plug is connected to the jack, the remote sensor
does not receive infrared rays.
If the plug is connected to the jack, the remote sensor
does not receive infrared rays.
9 VOLTAGE selector
(Exept for the USA/CA models)
Select 120V or 230V according to the local power line
voltage. (Refer to page 2)
Select 120V or 230V according to the local power line
voltage. (Refer to page 2)
Rear Panel Descriptions