Garmin gpsmap 2110 Manuale Utente

I

NSTALLATION

 I

NSTRUCTIONS

You can install flush mount or install the GPS 17 on any standard 1" O.D. (Outer 

Dimension), 14 threads-per-inch marine mount. When mounting the GPS 17, the 

cable can be run externally, through the mounting panel, or through the center of 

the marine mount. 
The GPS 17 connects to the 18-pin Power/Data Cable on the  

GPSMAP 2106/2110 and provides the GPS/WAAS signal for the unit. If two 

or more GPSMAP 2106/2110 units are installed, only one GPS 17 needs to be 

installed.
To ensure the best reception, mount the GPS 17 in a location that has a clear, 

unobstructed view of the sky in all directions. Avoid mounting the GPS 17 where 

it is shaded by the boat’s superstructure, a radome antenna, or mast. Sailboat 

users should avoid mounting the unit high on the mast to prevent inaccurate speed 

readings caused by excessive heeling. The unit provides more stable readings if 

it is located nearer to water level. Mount the GPS 17 at least 3 ft away from 

(preferably above) the path of any radar beam or a VHF radio antenna. 

Temporarily secure the unit in the preferred mounting location and test for 

correct operation. With correct operation verified, permanently mount the unit. If 

interference with other electronics is experienced, try a different location.

  NOTE: Never paint the GPS 17 or clean it with harsh solvents.

1.  Cut out the Flush Mount Drilling Template provided on page 13, and tape it on the selected mounting location.
2.  Mark the center of each mounting hole by tapping the end of a center punch or pointed object with a hammer. If the cable is going to be 

installed through the mounting panel, mark the center of the additional hole.

3.  Drill the holes using the appropriate drill bits.
4.  Align the GPS 17 over the mounting holes and fasten it using M4 screws. The mounting threads in the GPS 17 are 8.10 mm deep. Do 

not use screws that thread into the GPS 17 deeper than 8 mm, or the case may be damaged.

 

Mounting holes

The GPS 17 can be installed with the coax through the panel 

or on the outside of the unit. If the coax is run through the 

panel, seal the outside exit area with marine sealant.

Radar

ABOVE - BEST

BELOW - OK

SS JAYHAW

K

3'

EMI (Electromagnetic Interference) 

from engine components

 

  NOTE: Mount the antenna at least 3 ft away from 

(preferably above) the path of any radar beam or a 

VHF radio antenna.