Sony SDM-S204E Manuale Utente
21
GB
Picture is fuzzy.
• Adjust the brightness and contrast (page 12).
• Adjust the pitch and phase (analog RGB signal only) (page 13).
• Adjust the smoothing (page 12).
• Adjust the pitch and phase (analog RGB signal only) (page 13).
• Adjust the smoothing (page 12).
x
Problem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1600
× 1200 on your computer.
Picture is ghosting.
• Eliminate the use of video cable extensions and/or video switch boxes.
• Check that all plugs are firmly seated in their sockets.
• Check that all plugs are firmly seated in their sockets.
Picture is not centered or sized
properly (analog RGB signal only).
properly (analog RGB signal only).
• Adjust the pitch and phase (page 13).
• Adjust the picture position (page 14). Note that some video modes do not fill the screen to
• Adjust the picture position (page 14). Note that some video modes do not fill the screen to
the edges.
Picture is too small.
• Set the zoom setting to “FULL2” (page 15).
x
Problem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1600
× 1200 on your computer.
Picture is dark.
• Adjust the brightness (page 12).
• Adjust the backlight (page 12).
• It takes a few minutes for the display to become bright after turning on the monitor.
• Adjust the gamma on the GAMMA menu (page 15).
• The screen might turn darker, depends on ECO mode you selected.
• Adjust the backlight (page 12).
• It takes a few minutes for the display to become bright after turning on the monitor.
• Adjust the gamma on the GAMMA menu (page 15).
• The screen might turn darker, depends on ECO mode you selected.
Wavy or elliptical pattern (moire)
is visible.
is visible.
• Adjust the pitch and phase (analog RGB signal only) (page 13).
Color is not uniform.
• Adjust the pitch and phase (analog RGB signal only) (page 13).
White does not look white.
• Adjust the color temperature (page 14).
Monitor buttons do not operate
(
(
appears on the screen).
• If “MENU LOCK” is set to “ON,” set it to “OFF” (page 16).
Resolution displayed on the menu
screen is incorrect.
screen is incorrect.
• Depending on the graphics board setting, the resolution displayed on the menu screen may
not coincide with the one set on the computer.
After turning off the main power,
the
the
1
(power) indicator stays
bright for a while.
• When the main power is on but the 1 (power) switch is not pressed, or when the monitor
is in the power saving mode, if you turn the MAIN POWER switch off, the 1 (power)
indicator may not turn off right away. This is not a malfunction.
indicator may not turn off right away. This is not a malfunction.
Symptom
Check these items