Sony STR-DE685
52
GB
Remote
Operations
Function
Button
POSITION** TV
Changes the position of
the small picture.
the small picture.
SWAP**
TV
Swaps the small and the
large picture.
large picture.
SUB CH
TV
Selects the preset
+/–**
channels for the small
picture.
picture.
P IN P**
TV
Activates the picture-in-
picture function.
picture function.
JUMP
TV
Toggles between the
previous and the current
channels.
previous and the current
channels.
WIDE
TV
Selects the wide picture
mode.
mode.
TV/VIDEO TV
Selects input signal: TV
input or video input.
input or video input.
** Only for Sony TVs with the picture-in-picture
function.
Notes
• When you press the function buttons (VIDEO 1,
VIDEO 2, VIDEO 3, DVD/LD), the input mode of
the TV might not switch to the corresponding input
mode that you want. In this case, press the TV/
VIDEO button to switch the input mode of the TV.
the TV might not switch to the corresponding input
mode that you want. In this case, press the TV/
VIDEO button to switch the input mode of the TV.
• Some functions explained in this section may not
work depending on the model of the receiver.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
component the above operation may not be possible
or may operate differently than described.
• The TV/SAT and PHONO functions are not
available for set operation.
Changing the factory
setting of a function button
setting of a function button
If the factory settings of the FUNCTION
buttons do not match your system components,
you can change them. For example, if you have
an MD player and a tape deck and you don’t
have a CD player, you can assign the CD/SACD
button to your tape deck.
buttons do not match your system components,
you can change them. For example, if you have
an MD player and a tape deck and you don’t
have a CD player, you can assign the CD/SACD
button to your tape deck.
Note that the settings of the TUNER and
FN SHIFT functions (VIDEO 1, VIDEO 2,
VIDEO 3, PHONO and MD/TAPE) button
cannot be changed.
FN SHIFT functions (VIDEO 1, VIDEO 2,
VIDEO 3, PHONO and MD/TAPE) button
cannot be changed.
1
Hold down the Function button whose
function you want to change (for
example, CD/SACD).
function you want to change (for
example, CD/SACD).
2
Press the corresponding button of the
component you want to assign to the
Function button (for example, 4 – Tape
deck).
component you want to assign to the
Function button (for example, 4 – Tape
deck).
The following buttons are assigned to select
the functions:
the functions:
To operate
Press
CD player
1
DAT deck
2
MD deck
3
Tape deck A
4
Tape deck B
5
LD player
6
VCR (command mode VTR 1*)
7
VCR (command mode VTR 2*)
8
VCR (command mode VTR 3*)
9
TV
0
DSS (Digital Satellite Receiver)
>10
DVD
ENTER
VCD player
.
* Sony VCRs are operated with a VTR 1, 2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
VHS respectively.
Now you can use the CD/SACD button to
control the tape deck.
control the tape deck.
To reset a button to its factory
setting
setting
Repeat the above procedure.
To reset all the function buttons to
their factory setting
their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
the same time.
Remote button description
(continued)
(continued)