Sony S9 Manuale Utente
9
GB
3
Turn on the computer.
The installation of your monitor is complete. If necessary, use the
monitor’s controls to adjust the picture (page 10).
monitor’s controls to adjust the picture (page 10).
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
•
If “NO INPUT SIGNAL” appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
key on the keyboard or moving the mouse.
•
If “CABLE DISCONNECTED” appears on the screen:
Check that the video signal cable is properly connected.
•
If “OUT OF RANGE” appears on the screen:
Reconnect the old monitor. Then adjust the computer’s
graphics board within the following ranges.
graphics board within the following ranges.
For more information about the on-screen messages, see “Trouble
symptoms and remedies” on page 18.
symptoms and remedies” on page 18.
No need for specific drivers
The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
Setup 5: Adjusting the tilt
This display can be adjusted within the angles shown below.
Grasp the sides of the LCD panel, then adjust screen
angles.
angles.
SDM-S93 only
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
Note
When adjusting the screen tilt and height, proceed slowly and carefully,
being sure not to hit the monitor against the desk.
being sure not to hit the monitor against the desk.
SDM-S53
SDM-S73/S93
Horizontal
frequency
frequency
28–61 kHz
28–80 kHz
Vertical
frequency
frequency
48–75 Hz
48–75 Hz
Resolution
1024
×
768 or less
1280
×
1024 or less
approx.
30°
30°
approx.
5°
5°
MENU
OK
ECO
approx. 175°
approx.
175°
175°