Sony UP-DR80 Manuale Utente

18

Precautions

  Mis

c

e

llane

ous

Remove the paper that is ejected after thermal head 
cleaning is performed.

Press and hold the STOP button, and release the 
button when the CLEANING indicator flashes.
About 20 cm of paper is fed out of the printer from the 
paper outlet.

Attach the cleaning sheet to the partially ejected 
paper, and remove the backing paper.

• Orient the scratched printout that you kept in the 

direction it was facing when ejected, and use it to 
align the position of the cleaning sheet with the 
position of the scratches.

• Press the cleaning sheet with your finger to make 

sure that it is firmly affixed.

• Make sure there is no air trapped under the cleaning 

sheet and the corners of the sheet are not curling up. 
Such cases will result in paper jams.

• If air is trapped under the cleaning sheet, be sure to 

press it out.

Press the STOP button.
Roller cleaning with the cleaning sheet starts.

When cleaning finishes, the paper is ejected and the 
CLEANING indicator remains lit.

• The cleaning sheet is ejected with the paper. 

Discard the paper and do not reuse it.

• To perform roller cleaning again, repeat the 

procedure from step 3.

• If an error occurs, restart the procedure from step 1.

Make sure that the printer is not performing an 
operation, and then pull out the media tray.

Remove the cleaning ribbon.

Load the ink ribbon.

Insert the media tray into the printer.
This completes the cleaning procedure.

• As paper is used during cleaning procedures, the 

specified number of prints possible with a paper roll may 
be reduced if the same roll is used for multiple cleaning 
procedures.

• If there is not enough paper, the paper on which the 

cleaning sheet is attached may remain on the paper 

Lit

Flashing

Attach the cleaning 
sheet vertically in the 
position where the 
scratches appeared.

When attaching the cleaning 
sheet, align its edge with the 
edge of the paper outlet.

Paper 
outlet

Paper outlet

Flashing