Panasonic sc-ht845 Manuale Utente

5

RQT8225

[HT845]

[HT885]

[Note]

≥To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while assembling the speaker stands.

≥[HT885] The front and surround speaker pairs as well as the pipe pairs are different.

–Check the label on the rear of the speaker before attaching the pipe (

➜ page 6).

–The pipe with the shorter cable is for the front speaker.

1

Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not 
crease), pass the folded portion through the hole, and then pull 
the rest of the cable through the base.

2

3

Secure the pipe to the base.
Ensure the screws are securely fastened.

Ensure the stand is fastened on straight by gradually tightening the 
top and bottom screws alternately until fully tightened.

You can also attach to the lower rear of the speaker.
The height of the speaker can be changed when attaching the 
stand to the upper rear or lower rear of the speaker.

∫ Preventing the speakers from falling over

Preparation
Attach screw eyes (not included) to secure the speakers to the wall 
(

➜ diagram right).

≥You will need to obtain the appropriate screw eyes to match the 

walls or pillars to which they are going to be fastened.

≥Consult a qualified housing contractor concerning the 

appropriate procedure when attaching to a concrete wall or a 
surface that may not have strong enough support. Improper 
attachment may result in damage to the wall or speakers.

[HT885] 2 Front and 
2 Surround

 speakers

[HT885] 
4 Bases

[HT885]
8 Long screws

[HT885]
8 Short screws

[HT845]

[HT845]

[HT845]

[HT845]

[HT845]

[HT885]  4 Pipes
≥2kpipes with short cable: 

For front speakers

≥2kpipes with long cable: 

For surround speakers

Leave the excess speaker 
cable for connecting later.

Insert the pipe while gently 
pulling on the speaker cable.

Match the groove and these 
holes with the base when you 
insert the pipe.

Phillips-head 
screwdriver (not included)

Before proceeding to the next step, please remove the plastic 
wrap from the pipe.

§

_:

 Copper

`:

 

Silver

If there is any excess speaker cable, thread the speaker cable 
into the opening near the top of the pipe while pulling the speaker 
cable from the bottom of the base.

§ 

If the speaker cables do not have vinyl 

tips, directly connect them to the 
terminals.

String (not included)

Screw eye (not included)

[HT535]

String (not included)

Screw eye (not included)

[HT845]

 

[HT885]

HT535_845_885En.book  Page 5  Tuesday, April 19, 2005  11:42 AM