Panasonic cy-vm7203n Manuale Utente

10

11

 Remove and dispose of an old battery immediately. 
 Do not disassemble, heat or short a battery. Do not 

throw a battery into a fi re or water. 

 Follow local regulations when disposing of a battery. 
 Improper use of a battery may cause overheating, 

an explosion or ignition, resulting in injury or a fi re. 

 Keep a battery away from children to avoid the 

9

10

 Execute “ACC SELECT” setting. (page 24)

 Execute “ID-CODE” setting. (page 24) 

Note:
 The number in parenthesis underneath each accessory 

part name is the part number for maintenance and 
service. 

 Accessories and their parts numbers are subject to 

modifi cation without prior notice due to improvements.

1

Remote Control Unit
(EUR7641050)

1

1

Power Connector 
(YAJ024C119CA)

1

Wiping Cloth
(YEFX9991793)

1

Operating Instructions 
(YFM284C545ZA)

1

1

 Execute “DIMMER”, “CONTRAST”, “BRIGHT”, “COLOR” 

or “TINT” setting. (page 18) 

 Execute “TILT” (tilt angle adjustment) setting. (page 

22) 

 Execute “OPEN/CLOSE” (monitor setting when power 

on) setting. (page 22) 

You may need to set the following depending on the 
devices to be connected. 

 Execute “NAVI INPUT” (Navigation Input Selection) 

setting. (page 20) 

 Execute “CAMERA SETUP” (Rear View Camera Setup) 

setting. (page 20) 



 Remove the battery holder with the remote control unit 

placed on a fl at surface. 

 

  Stick your thumbnail into the groove, and push 

the holder in the direction of the arrow at the same 
time. 



 Put a battery in the case with (

) side facing up. 



 Put the case back.

Pull the insulation fi lm out 
from the backside of remote 
control gently. 

 

  Pull it out in the direction 

of the arrow using a 
tough pointed object.

Tough pointed object

Back side

Note:
 Battery Information: 
  Battery Type: Panasonic lithium battery (CR2025) 
  (Included in the remote control) 
  Battery Life: Approximately 6 months under normal use 

(at room temperature)