Panasonic KX-TG2248S Manuale Utente

 

“

 

No link to base. 

Place on cradle and 

try again.

 

” is displayed 

and an alarm tone sounds.

• You are too far from the base unit. Walk closer 

and try again.

• Place the handset on the base unit and try 

again.

• Plug in the AC adaptor.
• Raise the base unit antenna.

Static, sound cuts in/out, 
fades. Interference from other 
electrical units.

• Move the handset and the base unit away 

from other electrical appliances (p. 3).

• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 23, 36).

The handset does not ring.

• The ringer volume is set to OFF. Set to HIGH, 

MEDIUM or LOW (p. 17).

The handset display is blank.

• Charge the battery fully (p. 8).

You cannot program function 
items.

• Programming is not possible while the unit is 

being used.

• Do not pause for over 60 seconds while 

programming.

• Walk closer to the base unit.

While programming or 
searching, the unit starts to 
ring and stops the program/
search.

• A call is coming in. To answer the call, press 

 

or 

 

. Start again from the beginning 

after hanging up.

You cannot make a call with 
the handset.

• Your handset is in remote operation mode 

(p. 41). Exit by pressing 

 

.

You cannot redial.

• If the last number dialed was more than 

32 digits long, the number will not be redialed 
correctly.

The unit does not display the 
caller’s name and/or phone 
number.

• You need to subscribe to a Caller ID service.
• Other telephone equipment may be interfering 

with your phone. Disconnect it and try again.

• Other electrical appliances connected to the 

same outlet may be interfering with Caller ID.

• Telephone line noise may be affecting Caller 

ID.

• The caller requested not to send his/her 

Caller ID information (p. 25).

• If a Caller ID box is connected between the 

unit and the telephone wall jack, disconnect 
the Caller ID box or plug the unit directly into 
the wall jack.