HP 457626-001 Manuale Utente

Pagina di 103
 
 
Contents 39 
 
 
 
Powering Down the Server 
The server does not completely power down when the power button on the front panel is pressed. The 
button toggles between On and Standby. The standby position removes power from most electronics 
and the drives, but some internal circuitry remains active. To completely remove all power from the 
system, disconnect all power cords from the server. 
To power down the server: 
1. 
Shut down server as directed by the operating system documentation. 
2. 
Press the power button to toggle to Standby. 
This places the server in standby mode changing the power LED indicator to amber. In this 
mode, the main power supply output is disabled. Standby does not completely disable or 
remove power from the system. 
3. 
Disconnect the AC power cord from the AC outlet and then from the server. 
4. 
Be sure that the power LED indicator is turned off and that the fan noise has stopped. 
5. 
Disconnect all external peripheral devices from the server. 
System Covers 
The top cover and top middle cover are both detachable. You need to remove the top cover before 
you can remove or replace a server component. The middle cover needs to be removed to service the 
SAS/SATA backplane board and optical drive. 
Top Cover  
To remove the top cover: 
1. 
Loosen the captive screw on the rear panel with a T-15 screwdriver. 
2. 
Slide the cover approximately 1.25 cm (0.5 in) toward the rear of the unit and then lift the cover 
to detach it from the chassis. 
3. 
Lift the top cover away from the chassis.