Panasonic th 103vx200u Manuale Utente

     When the battery is running low, the indicator lamp fl ashes 5 times on turning the 3D Eyewear on. In this case, early 

battery replacement is recommended.

    •  Dispose of the old batteries as non-burnable rubbish, or in line with the waste disposal regulations in your local area.

  Loosen the screw and remove the battery cover using the supplied screwdriver

Screwdriver (supplied)

Battery cover

  Replace the battery

•  Use the specifi ed type of battery (coin-shaped lithium battery CR2032).
•  Note the correct polarity (+ or -).

  Replace and fasten the battery cover

Battery cover

•  Make sure that the screw is tightened.

    Use either nose pad A or B for your preference.
    • If you put the 3D Eyewear on vision correction glasses, the nose pad is recommended to be removed.

Nose pad A

Nose pad B

or

•  You can select the positions of the nose pad A from the 2 levels of height. 

Use upper 2 protrusions or lower 2 protrusions on the 3D Eyewear to attach 

the nose pad A.

•  Use all 3 protrusions on the 3D Eyewear to attach the nose pad B.

    If the 3D Eyewear slips out of place, use the supplied specialised band to hold it in place.
    • Attach the band to the left and right tips of the frame, and adjust the length.

Specialised band

Frame

Push to adjust the 

length of the band

When the end of the specialised band is straightened, form a loop at the end of the band, and fi x the twisted 

part.

• Treat the rubber part carefully not to break it.

Fix the 

twisted part

• Use the supplied 3D Eyewear case to store the 3D Eyewear.
• Avoid storing the 3D Eyewear in hot or highly humid locations.
• Use a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
• Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
• Do not submerge the 3D Eyewear in liquid such as water when cleaning.