Panasonic th70lf50u Manuale Utente
49
Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT”
to “LAN”. (see page 45)
When “LAN” is set, power indicator lights orange under the condition of power off with remote control (stand-by state).
Note:
To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT”
to “LAN”. (see page 45)
When “LAN” is set, power indicator lights orange under the condition of power off with remote control (stand-by state).
Example of Network Connection
Command Control
Display (main unit, rear)
Hub or broadband router
LAN cable
(not supplied)
(not supplied)
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “category 5” LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “category 5” LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 16)
Commands used in the serial control are supported. (see page 16)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Consult your local Panasonic dealer for detail instructions on command usage.
COMPUTER