Panasonic wj-fs216 Manuale Utente

-9-

The buzzer beeps when this unit receives the alarm
signal.  You can adjust the buzzer time between 1
and 60 seconds by changing the ALARM BUZZER
parameter.

1. Move the cursor to the ALARM BUZZER parameter.
2. Select the buzzer time.

The alarm buzzer does not beep when the

alarm signal is received.

The buzzer keeps on beeping for the

duration you set.  The letter “S” stands for sec-
onds.

The factory setting is 2S.

2. Select the duration the alarm signal is output.

The alarm signal is output for the dura-

tion you set. The letter “S” stands for seconds.

The factory setting is 2S.

When alarm is received, the alarm signal is sup-
plied to the other device through the
ALARM/REMOTE connector.  You can adjust the
duration the alarm signal is output between 1 and
60 seconds.

1. Move the cursor to the ALARM OUTPUT parameter.

2. Select the recording mode.

The output signal to be recorded on

the VTR is switched each time after the number
of fields you have set.

The recording output signal is supplied to the

VTR for time lapse recording.

The factory setting is 4 FIELDS.

When T/L is selected and no camera switching
signal supplied, there will be no correct time
lapse recording.  In this case, either supply the
camera switching signal or select 4 - 255 fields
in REC mode for normal recording.

The recording mode can be set to 4-255 fields or
time lapse recording.

1. Move the cursor to the REC MODE parameter.