Panasonic workio kx-cl510 Manuale Utente

To avoid machine malfunction, do not use the equipment under the following conditions:

■ Static Electricity Damage

To prevent static electricity damage to any of the following components, touch a grounded metal surface, such as the 
printer's bare metal frame prior to touching the component.
• Interface connectors: parallel, USB, network, and connector for optional paper feeder
• Connector pins on the optional paper feeder
• Electrical components, connectors inside the printer

■ Interface Cable

Always use a shielded interface cable. Use of an unshielded cable can result in radio interference with data.

■ Power Source

The voltage level of the power source must not vary more than ±10% from the voltage level marked on the nameplate 
(located on the rear of the unit).
Do not use an extension cord.
Do not use a line conditioner, transient suppressor or surge protector as it may cause a machine error.

■ Ventilation Space

The ventilation space is needed more than 20 mm (0.8") between the printer and a wall.

Not genuine toner

• Direct exposure to sunlight.

• Extremely high or low 

temperature [temperature 
range: 10

°C to 32.5°C (50°F 

to 90.5

°F)]

• Extremely high or low 

humidity. (humidity range: 
15% to 80% RH)

• Condensation due to rapid 

change of temperature.

• Areas of poor ventilation.

• Areas of high dust or 

chemical fume concentration. 
(solvent etc.)

• Unstable or unlevel surfaces.

• A very large stack of media 

into the manual feed.

• Directly in front of air 

conditioning vents.

• Liquids near the equipment.

• Any toner other than genuine 

Panasonic toner; it may 
damage the printer.

Media for ink jet (paper, 
transparency, etc.) 

Before You Start