DELL 1100-b110 Manuale Utente

Appendix

85

Lists the drives in the order by which they boot. 

• Floppy device - Identifies and defines the floppy drive attached to the 

FLOPPY connector on the system board. If there is no installed drive, it 
appears as Floppy device (not installed). 

• Hard-Disk Drive - Identifies the hard drive. The drive is listed by its drive 

letter (such as Hard Disk Drive C:). 

• IDE  -  Identifies and defines the optical drive attached to the IDE 

connector on the system board. If there is no installed drive, it appears as 
IDE CD-ROM Device (not installed). 

An included device displays with a checkmark next to its listing. To remove 
the device from the boot sequence, use the spacebar to clear the checkmark. 
To change the boot order, use + or - to move the listing up or down.

Installed System 

Memory

Identifies and lists the amount of detected memory.

System Memory 

Speed

Identifies and lists the speed of the detected memory in megahertz (MHz). 
For information on supported memory see "Memory" on page 79. 

System Channel 

Mode

Identifies and lists the installed memory as either Dual or Single channel. 
For information on supported memory see "Memory" on page 79. 

AGP Aperture

Identifies and lists the amount of memory to dedicate for graphics. The 
values vary depending on the capacity of installed memory.

Hyperthreading

If your computer’s processor supports Hyper-Threading, This section 
displays the following options:

• Disabled - Hyper-Threading is Off.
• Enabled - Hyper-Threading is On.

CPU Speed

Lists the options for setting the processor speed as Normal or Compatible.

NOTICE: 

Changing the CPU Speed is not recommended, this may shorten the 

life of the processor and void the warranty.

Bus Speed

Lists the speed that the processor runs in megaherz (MHz)

Processor ID

Lists the processor Clock Speed, and L2 Cache Size.