JVC GR-D93 Manuale Utente

MasterPage: Video_Heading0_Right

Before continuing, perform the procedures listed below:

● Power (墌 pg. 6)

● Loading A Cassette (墌 pg. 10)

Remove the lens cap.

Open the LCD monitor fully. (

Set the VIDEO/MEMORY Switch to “VIDEO”. 

(GR-D93/73 only)

Set the Power Switch to “A” or “M” while pressing 

down the Lock Button located on the switch.

● The POWER/CHARGE lamp lights and the camcorder 

enters the Record-Standby mode. “PAUSE” is displayed.

● To record in LP (Long Play) mode, 墌 pg. 25, 26.

To start recording, press the Recording Start/Stop 

Button. The “T REC” appears on the display while 
recording is in progress.

To stop recording, press the Recording Start/Stop 

Button again. The camcorder re-enters the Record-
Standby mode.

● The image will not appear simultaneously on the LCD 

monitor and the viewfinder.

● If the Record-Standby mode continues for 5 minutes, the 

camcorder’s power shuts off automatically. To turn the 
camcorder on again, push back and pull out the viewfinder 
again or close and re-open the LCD monitor.

● LCD monitor/viewfinder indications:

• When power is supplied from a battery: the “

” 

battery indicator is displayed. (

• When power is supplied from an AC outlet: the “

” 

battery indicator does not appear.

● When a blank portion is left between recorded scenes on 

the tape, the time code is interrupted and errors may occur 
when editing the tape. To avoid this, refer to “Recording 
From The Middle Of A Tape” (

● To turn the beep sounds off, 墌 pg. 25, 27.

● For other notes, 墌 pg. 38.

GR-D73US.book  Page 11  Thursday, November 20, 2003  10:50 AM