JVC UX-G60 Manuale Utente

⁄

 

• To select progressive scanning mode (see page 14), use 

COMPONENT jacks.

• After connecting a TV, select the proper video signal mode 

according to the connection method. See “Changing the 
Scanning Mode” on page 14.

@

 

• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu 

correctly according to the connected digital audio 
equipment (see page 36). If the setting is incorrect, loud 
noise may be generated causing damage to the speakers.

• By using QP Link (Quick Portable Link), you can easily 

start playing back a portable audio device on this unit. See 
page 11 for details.

• If an external device is not equipped with a stereo mini plug 

audio output, use a plug adaptor to convert the stereo mini 
plug to the corresponding plug of the audio output.

• You can connect a USB mass storage class device such as a 

USB flash memory device, hard disk drive, multimedia card 
reader, etc. to this System. See pages 10 and 38 for details.

• If you press USB MEMORY 

3

 

, the System detects the 

USB mass storage class device and the control screen 
appears on the TV screen. See page 26 for details.

 

Set the correct voltage for your area with the voltage selector 
on the rear.

 

• Dispose of batteries in the proper manner, according to 

federal, state, and local regulations.

 

Point the top of the remote control toward the remote sensor 
as directly as possible. If you operate it from a diagonal 
position, the operating range (approx. 5 m) may be shorter.

Green

Blue

Red

Protective cap

At the front 
panel

 

DO NOT recharge, short, disassemble, heat 
the battery or dispose of it in a fire.

At the front 
panel

Use a screwdriver to set the voltage 
selector to the same voltage as 
where you are plugging in the unit. 
(See also the back cover page.)

R6(SUM-3)/AA(15F)

UX-G60[U]_2.book Page 5 Tuesday, February 7, 2006 5:16 PM