Sanyo PLC-HF10000L Manuale Utente

Installation

Lens Installation

Before setting up the projector, install Projection Lens on the projector.

Before installation, check where the projector is used and prepare a suitable lens. For the specifications of

Projection Lens, contact sales dealer where you purchased the projector.

- Do not use the optional lens below for this projector. Otherwise damages may result.
LENS MODEL NO. : LNS-T01, LNS-T01Z
- Lens installation and replacement should be performed by the qualified service personnel.

- When setting the projector after lens installation, be sure to replace a Lens Cap to protect a

surface.

- When carrying or holding up the projector, be careful not to put your hands on lens part. It may

damage lens, cabinet, or mechanical parts.

Attaching the Strap

Connect the lens mount cover and the projector with the

strap (supplied) to prevent the lens mount cover from

falling down.

Fig. 1

Fig.

Label

Matchmark (dot) on the cabinet
Matchmark (dot) on the lens mount

cover

Strap

Remove the screw. (See Fig. 1)

Turn the lens mount cover counter-clockwise.

(See Fig. 1)

Thread one end of the strap through the loop hole

on the lens mount cover. (See Fig. 2)

Fig.

Strap

Lens Mount Cover

Screw

Fix the other end of the strap to the projector

with the removed screw. (See Fig. 3)

✔

Note:

• The screw which is packed with the strap is not for use

with this projector.

Lens Mount Cover

Loop Hole

Fit the lens mount cover, align the matchmark on the lens mount

cover with the left edge of the label on the cabinet, and then turn

the lens mount cover clockwise until it clicks. (See Fig.3)

Screw