Sanyo PLC-HF10000L Manuale Utente

Maintenance and Care

Check the number of lamp to be replaced on the Lamp

Status Display.

Loosen a screw on the Lamp Cover. Slide and open the

Lamp Cover. (See the right figure.)

Loosen two screws and pull out the Lamp to be replaced

by grasping handle.

Turn off the projector, press the Main On/Off Switch to Off

and unplug the AC power cord from the AC outlet. Let the

projector cool for at least 45 minutes.

Replace the Lamp with a new one and tighten two

screws. Make sure the Lamp is set properly.

Follow these steps to replace the lamp.

Put the Lamp Cover back and tighten a screw.

SCREW

LAMP
COVER

Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 1.

CAUTION : DO NOT OPERATE THE PROjECTOR WHILE

ANy OF LAMPS IS REMOVED. IT MAy

RESULT IN MALFUNCTIONS, FIRE HAZARD,

OR OTHER ACCIDENTS.

NOTES ON LAMP REPLACEMENT

To maintain quality of picture (better balance of color

and brightness in entire screen), we recommend

replacing both lamps at a time.

Lamp Replacement

For continued safety, replace with a lamp assembly

of the same type.

Do not drop the lamp assembly or touch a glass

bulb! The glass can shatter and may cause injury.

Allow the projector to cool, for at least 45 minutes

before you open Lamp Cover. The inside of the

projector can become very hot.

CAUTION

TURN OFF THE UV LAMP BEFORE

OPENING THE LAMP COVER.

WARNING:

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the

screen and LAMP 1/2 REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing

when the LAMP 1/2 REPLACE indicators should light is depending on the lamp mode.

Indicators

LAMP 1 / REPLACE indicators

Lamp replacement icon

✔

Note:

• The Lamp replacement icon will not appear

when the Display function is set to “Off” (p.53),

or during “Freeze” (p.30).

SCREWS

LAMP 2

LAMP 1