kymco mo mxu250 Manuale Di Servizio
17
. IGNITION SYSTEM
17-7
MXU 250
Measure the spark plug cap resistance.
Remove the spark plug cap and measure the
Remove the spark plug cap and measure the
spark plug resistance.
Resistance: 4.2~5.2K
Resistance: 4.2~5.2K
Ω/20◦C
PERFORMANCE TEST
Test the performance with a ignition unit
Test the performance with a ignition unit
tester.
If the spark is weak, inspect the spark plug
and ignition unit. If both of them are normal,
replace the ignition coil with a new one.
PULSER COIL
INSPECTION
Remove the front fender. (Refer to the
Remove the front fender. (Refer to the
chapter 2)
Disconnect the pulser coil wire coupler and
Disconnect the pulser coil wire coupler and
measure the resistance between the blue/
yellow and green/white wire terminals.
Resistance: 105~110
Resistance: 105~110
Ω/20◦C
Refer to the “A.C.
GENERATOR/FLYWHEEL” section in the
chapter 16 to remove or install.
Ignition Coil
CDI Unit
Spark Plug
CDI Tester
• Operate the ignition unit tester by
following the manufacturer‘s
instructions.
• Use the special connector to connect
the ignition unit.
*
Measure the resistance in the XK
Ω range
of the electric tester.
*