Emerson NGA2000 Manuale Utente

NGA 2000

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

↓↓

System set up

↓↓

Front panel control

↓↓

In the menu "Front panel control" you can set up several display parameters.

Set up parameters:

♦ 

Select any line of variables or the menu line with the 

↓↓

 -key or the 

↑↑

 -key.

♦ 

Select the variable with the ENTER key or the 

→

→

 -key.

♦ 

Select any digit with the 

←

←

 -key or the 

→

→

 -key and adjust a new value with

the 

↑↑

 -key or the 

↓↓

 -key

resp. select the whole parameter with the 

↑↑

 -key or the 

↓↓

 -key.

♦ 

Confirm the new value with the ENTER key or cancel and go back to the last value with
the F2 key.

Lines of variables "LCD brightness" and "LCD viewing angle":

In these two lines you can determine the quality of the LCD reproduction. The best values
depend on your position to the screen and on the light of the environment.

♦ 

Options: 20 to 100% for LCD brightness and 10 to 80% for LCD viewing angle.

♦ 

Usually: 70 to 90% (brightness) and 20 to 30% (angle).

♦ 

Caution: Be careful with the changing of these values! Perhaps you can not read the
display any longer if you use very extreme values! It is not possible to load standard
values via keyboard!

Lines of variables "Beeper enable" and "Beeper frequency":

The functionality of these two lines is not available at the moment!

HOME

ESCAPE

INFO

CLD

95.0 ppm

Front Panel Control

LCD brightness:

70 %

Beeper enable:

Off

Beeper frequency:

1.00 kHz

Reading refresh rate:

1 s

Drop out of menus after:

10 min

Date and time...

LCD viewing angle:

25 %