Escalade Sports 2l-6742-02 Manuale Utente
Page 3
OUTDOOR 2000
ASSEMBLY INSTRUCTIONS
BE SURE TO SAVE THE 4 FOAM PIECES UNDER THE
TABLE COVER. YOU WILL BE USING THESE WITH YOUR
TABLE COVER.
TABLE COVER. YOU WILL BE USING THESE WITH YOUR
TABLE COVER.
The foam pieces are used when the table is covered to serve as a
Buffet Table. The foam levels the surface under the table cover.
Buffet Table. The foam levels the surface under the table cover.
2.
After securing the pedestals to the frame, you will need to
get at least 4 capable adults to help.
Rotate billiard table carefully onto its side while still protected by
the shipping carton. See Fig.2.
the shipping carton. See Fig.2.
This table weighs approximately 650 lbs when fully assembled.
Proceed slowly and continue to rotate pool table until it is in
an upright position as pictured in Fig.3.
Proceed slowly and continue to rotate pool table until it is in
an upright position as pictured in Fig.3.
Rotate Over Into Upright Position
Bolt the pedestals to the frame using the bolts,
washers, and nuts provided. Be sure to tighten securely
washers, and nuts provided. Be sure to tighten securely
Fig.1
Attach Legs
1. READ THIS MANUAL CAREFULLY BEFORE STARTING ASSEMBLY
Read each step completely before beginning each step.
Read each step completely before beginning each step.
2. SOME SMALLER PARTS MAYBE SHIPPED INSIDE LARGER PARTS, CHECK ALL CARTONS FOR KITS.
3. USE THE HARDWARE IDENTIFIER TO IDENTIFY AND SORT ALL FASTENERS ( See Page 2).
CHECK ALL CARTONS FOR KITS.
CHECK ALL CARTONS FOR KITS.
T
T
T
T
This
his
his
his
his T
T
T
T
Ta
aa
aab
bb
bble is contained in tw
le is contained in tw
le is contained in tw
le is contained in tw
le is contained in two se
o se
o se
o se
o separ
par
par
par
para
aa
aate container
te container
te container
te container
te containers:
s:
s:
s:
s:
Container #1......Contains top section of table and owner’s manual.
Container #2......Contains two pedestal assemblies and hardware kit.
1.
Place large master (main) table carton on floor and remove
topside of box from master carton. With bottom carton flat on
floor, unpack pedestals carton and position pedestals on table
frame as shown in Fig.1.
floor, unpack pedestals carton and position pedestals on table
frame as shown in Fig.1.
Align bolt holes and attach pedestals using (8)Hex Bolts #2,
(16)Flat washers #3, (8)Hex Nuts #4, (8)Split Lock washers #7.
(See page 2 for details)
(16)Flat washers #3, (8)Hex Nuts #4, (8)Split Lock washers #7.
(See page 2 for details)
Fig.2
IT IS ALSO NECESSARY TO ALWAYS COVER THE TABLE
WITH FOAM PIECES INSTALLED SO WATER WILL NOT
GATHER AND POOL ON THE VINYL TABLE TOP DURING RAIN.
WITH FOAM PIECES INSTALLED SO WATER WILL NOT
GATHER AND POOL ON THE VINYL TABLE TOP DURING RAIN.
Fig.3