Echo shc-1700 - type 1, shc-1700 - type 1e, shc-2100 - type 1, shc-2100 - type 1e, shc-2400 - type 1, shc-2400 - type 1e, hca-2400 - type 1e Manuale Utente

Blades should not move at idle. If blades move, readjust carbure-
tor according to Carburetor Adjustment instructions in the
manual or see your ECHO dealer, otherwise serious personal
injury may result.

1.

Ignition Switch - Start/Run. (All Models)
Move Ignition Switch lever/ button away from the STOP position.

2.

Close Choke - Cold Start.
- SHC-1700, 2100 -Push choke lever forward to Cold Start.
- SHC-2400, HCA-2400 - Pull choke lever up to Cold Start position.

3.

Primer - Pump Bulb. (All Models)
Pump primer bulb until fuel is visible in the “Clear” fuel return line.

4A. Starting  (SHC-1700, 2100)

Lay the trimmer on a flat, clear area. Grip front handle interlock.
Place knee (light pressure) against upper drive shaft to hold power
head on the ground. Pull starter rope until engine fires.

NOTE
Ignition Interlock Lever in front handle must be gripped for the
engine to start and/or to continue to run.

4B. Starting (SHC-2400)

Lay the trimmer on a flat, clear area, clear area and pull starter rope
until engine fires.

4C. Starting (HCA-2400)

Lay the trimmer on a flat, clear area. Firmly grip the rear handle and
depress and hold the "Ignition/Throttle Interlock". Pull the starter
rope until engine fires.

NOTE
Idle/Start Interlock" must be held tight against the grip or engine
will stop at idle.

5.

Open Choke - Run (All Models)
Push choke lever back to "OPEN - RUN" position. Restart engine
if necessary and allow to warm up running at idle for several
minutes.